FLProg

Visual programming for not programmers

Яндекс.Метрика
Signal receiver IR remote


Block is used to allow use in the receiver of remote IR. In the block settings you can select the required number of outputs which when you click on a certain button of the remote will appear the high level. The output V is issued the command code and the output of the MC will appear for the manufacturer's code, and the output CS code size in bits.
The codes for the manufacturer the following:
NEC - 1
SONY - 2
RC5 - 3
RC6 - 4
DISH - 5
SHARP - 6
PANASONIC - 7
JVC - 8
SANYO - 9
MITSUBISHI - 10
SAMSUNG - 11

If you select "Reset outputs after receiving code" after it is tempered the remote control outputs of the unit will be reset to 0 if you disable this option, all the time until reception of a new command block outputs will remain in last state


Necessary codes the remote control buttons you must select from the file


To create the file buttons, you can use the tool "Recording codes buttons on IR remote"


To record the codes of the buttons you need to follow a few simple steps



For all codes of the buttons you can use the same file. When you select an existing file, the program will add new codes to the buttons in the file.