FLProg

Visual programming for not programmers

Яндекс.Метрика
Software specifying the address of the Slave device in a Modbus network


Block is used to specify the address of the slave during operation of the controller. The slave is tied to the block is assigned to the address specified on the input value "SlaveId". The block is configured using the editor block


If checked, the Output current Slave Id of the unit appears to output "CuSlId" which will be the value of the current address to this slave. When installing tick "enable recording" the bloc will see the entrance to "Save". Assigning the slave the new address will occur on the rising edge on this input. Will also be possible to store the assigned address value in non-volatile memory and restoring this value after the controller is restarted.


Each slave in the project you can use only one block of the set address