FLProg

Visual programming for not programmers

Яндекс.Метрика
Speed setting Modbus


The unit is used for setting the exchange rate of the UART port to work Modbus Protocol during operation of the controller. The port attached to the unit sets the speed in accordance with the input value "SpIdx" on the table.


Block parameteres when using the editor unit


If checked, the Output current of the speed index" section appears the release of "CuSpId" in which the value of the current index for the given port. When installing tick "enable recording" the bloc will see the entrance to "Save". The new speed will occur on the rising edge on this input. Will be able to maintain rated speed value in non-volatile memory and restoring this value after the controller is restarted.


For each of the ports (Modbus Master and Modbus Slave) the project can only use one block "Setting port speed"