Adding points to the waveform
Block is used to add point to the chart item's Waveform. The block parameters are set in the editor block
First select or create a panel. Existing in the project panel, you can choose from the dropdown list. To create a new panel click the button with the + on the right panel. Window opens added panel.
In this dialog you must select the UART port is connected to the panel, and configure it if necessary. It is also necessary to specify the name of the panel.
In this dialogue there is the possibility to add comments to the panel, create pages and elements included in the page.
After selecting or creating a panel, you must select or create a page. When you click add page opens the corresponding window.
In this window you should enter the page name and ID, which were received in the interface editor Nextion HMI while creating this page
Set "Start page" when starting the controller to be migrated to this village. If this box not be installed on any page, homepage will be the page with the lowest ID.
Also in this window it is possible to add items to this page.
After you select or create the page you need to choose or create the element that will receive the point.Select only elements WaveForm. To add an item just click add. Opens the add element
In this window you must select the type of the element type, name, ID. As in the case of global visibility of the element you have to select "Global". These parameters can be found in the interface editor Nextion HMI
It is also necessary byboat channel graphics which will print point. The point value can be set constant, or read from input "Value".
The upload mode you can select from three options:
1. "In every cycle". In this mode, the sending will be carried out in each cycle of program execution. It is not recommended as this mode is very heavy controller and increases the run time of the program.
2."The rising edge at the input Get.
3. "Periodically". Shipping is done pereiodicheski with a given period of time