FLProg

Visual programming for not programmers

Яндекс.Метрика
Sending a command to turn on the calibration mode panel


Block is used to send the command to activate the calibration panel Nextion HMI. Sending the command is performed on the rising edge at the input "Send". The selection panel is made by the editor unit.


Selected or created the panel. Existing in the project panel, you can choose from the dropdown list. To create a new panel click the button with the + on the right panel. Window opens added panel.


In this dialog you must select the UART port is connected to the panel, and configure it if necessary. It is also necessary to specify the name of the panel.
In this dialogue there is the possibility to add comments to the panel, create pages and elements included in the page.