FLProg

Visual programming for not programmers

Яндекс.Метрика
Save variable in the EEPROM


Block is used for variable write in a non-volatile memory of the controller. The rising edge pulse at input "EN" value from input "V" is recorded in the nonvolatile memory of the controller.
After adding the block to the diagram in the properties block, you must create a variable, assign it a name and type. For convenience, you can ascribe any necessary comments.



Control over the employment non-volatile memory is automatically, and when you try to create a variable when fully occupied memory, the message and the variable is not created.

Please note that the number of entries in the EEPROM is limited by the value 100,000 times. So try to write values to memory only when necessary. The number of reads from memory not limited