FLProg

Visual programming for not programmers

Яндекс.Метрика
The analog output connector


The analog connector is used to connect the analog circuits within the Board and between boards. The analog output connector is the response part of the input of the analog connector. On every connector possible single entrance and an unlimited number of outputs.
The analog outputs connector in the diagram can be created in several ways:

1. By dragging onto a diagram from the library of elements. The yield
the analog connector is created without reference.

2. Drag on the diagram the analog connector from the tree
the installed equipment. The analog output connector
is created attached to the connector.


Bind and rebind of the analog output connector is made in the following ways:
1. By dragging it to the analog output connector the analog connector from the tree of the installed equipment.

2. Editor block:


The binding is made by double clicking on the required connector